Vision Wet Look Floor Finish
Floor Preparation: Strip old finish and wax using your preferred NCL floor stripper following label directions. For baseboards and corners, use an NCL baseboard stripper following label directions. If necessary, rinse thoroughly with clean water and allow to completely dry.
Application: Using a clean mop or applicator apply thin uniform coats of VISIONS™ Wet Look Floor Finish. Allow to dry for a minimum of 20 minutes after each coat. Do not apply more than 4 coats in a 24 hour period. Floor should be thoroughly dry before traffic is allowed in area.
High Speed Buffing and Burnishing: This is an ideal product for use with high speed polishing or burnishing machines of 1000 rpm or higher. Prior to high speed buffing or burnishing the floor surface should be dust mopped using preferred NCL dust mop treatment. When buffing or dry burnishing, use NCL Aqua Magic™ Buffing Pad.
For spray buffing and for mop-on restoring use VIVID™ Laminator & Maintainer; for auto scrubbing, use preferred NCL maintainer.
Routine Maintenance: Dust mop using mop treated with an NCL dust mop treatment. Damp mop or clean with an automatic scrubber using your preferred NCL neutral floor cleaner following label directions.
Scrub and Recoat: When routine maintenance and buffing/burnishing no longer responds as needed, scrub and recoat using an NCL scrub and recoat cleaner following label directions.